Основные характеристики
Комплект поставки
Кабель питания | |
Предохранитель | 1 x 4A |
Руководство пользователя | |
Разъемы | 1 x 7-pin DIN |
1 x 13-pin DIN |
Amateur Radio General Features
10 MHz Reference I/O Port | Selectable as Off, Input or Output. Impedance = 50Ω. Input level = 0dBm ± 10dB. Output Level = 0dBm |
"Band Elimination Filter" | Offers selectable-width notch function (300-1200Hz in 100Hz steps) with selectable attenuation (20 – 80 dB in 20 dB steps) |
Built-in CW Keyer with Message Memories | |
Built-in Power Supply | Switched Mode PSU |
Built-in Voice Guide and Recorder | Fully configurable guidance including operating status, SWR, TX power, menus. |
Clock | Two clock displays (local/time-zone) plus date. Can be updated from NTP servers via the LAN port |
COM Port – D-sub 9-pin | |
Connectivity | 10MHz Ref Clock Oscillator I/O (BNC) |
External ATU port | |
Keypad (3.5 mm jack) | |
COM Port (Female 9-pin) | |
Straight/Paddle Key/External Keyer (6.3mm jack) | |
2 x USB-A & 1 x USB-B ports | |
"ACC-2" Data/audio connector | |
"Remote" linear connector | |
Analogue Meter (3.5mm jack) | |
"DRV" low-level LF drive (RCA) | |
Optical I/O | |
2 x external speaker sockets (3.5mm jacks) | |
DVI-I Dual-link video port | |
LAN port | |
Connector for External ATU | |
Connector for Remote/Linear Amp | |
CTCSS Encoder/Decoder | Single-tone and cross-tone functions |
Data Connection for External TNC | |
Digital Noise Limiter | |
Digital Optical Ports | Input = 44.1/48kHz 16/24-bit |
Output = 48kHz 24-bit | |
Dimmer Key | – for displays and LEDs. 4 dimmer levels |
Direct-access Band Buttons | 10 buttons for Amateur bands 1.8 – 50 MHz plus 2 buttons for General Coverage. Up to 5 band-memories per button |
Direct Frequency Entry | |
"DRV" Low Level Drive Output Terminal | RCA jack – 1 mW output covers 1.8 to 50 MHz bands plus the 135.80-137.70 kHz LF band. |
Dual Receive | |
DSP Devices | 3 x Analog Devices Inc SHARC 32-bit DSP chips |
for Main IF, Sub IF and Bandscope functions | |
DX Cluster Tune Function | With compatible external Kenwood transceiver |
Firmware Upgradeable via PC | |
Firmware Upgradeable via USB Port | |
Front Panel KeyPad | |
FSK Reverse Mode | |
Headphone Socket with Dual RX Output | Main and sub-Band RX audio can heard either mixed, or separated to the left/right channels |
High Frequency Stability | Yes |
Illuminated Front Panel Keys | |
Key Beep | – adjustable + OFF |
Key Lock | Yes |
LAN Port | |
Loudspeaker Socket | Two external loudspeakers can be connected via 2 x 3.5mm mono sockets. Impedance range 4 – 8 ohms |
Memory Channel Lock-out | |
Memory Channels with Alpha-tagging | 120 Memory Channels |
Memory Shift Function | |
Menu System for individual set-up | Switchable between CONFIG A and CONFIG B. Can also be saved to USB stick |
Microphone Socket | 8-pin "Chrome" type |
Monitor Function | |
Multiple Scan Functions | |
Mute Function | |
PC Radio Control Program (Option) | |
Power-On Message | |
Power-Off Timer | Configurable, including Timed Audio Recording |
Pre-amplifier | Configurable per band |
Pre-selector | Configurable |
Programmable Function Keys | 2 Front Panel PF keys plus up to 8 external/mic keys |
PSK31 Compatible | |
Receiver Hi-cut/Lo-cut DSP Slope Filters | |
Receiver Noise Blanker | |
Receiver Notch Filter Function | |
Remote Operation via the Internet | ARHP-990 Software allows remote operation |
Roofing Filter | Equipped with 270Hz, 500Hz, 2.7kHz, 6kHz and 15kHz as standard, plus space for optional 6th filter |
Screen Saver | Yes, Configurable – two styles including 10-character text for callsign, name etc. |
Sky Command 2 | With compatible external Kenwood transceiver |
Speech Processor | |
Sub Receiver | Equivalent to TS-590S main receiver |
TFT Colour Display | 2 TFT displays. 7" main display with operating information, Bandscope, Waterfall and touch-screen tuning function plus 3.5" sub display with audio scope, PSK tuning meter etc. Selectable background colours. 4 different styles of S-meter presentation. Sub-display includes X-Y function (FSK) or Vector function (PSK) |
Time-Out Timer | |
Transverter Display Function | direct entry of transverter frequency |
TX Audio Filter | |
TX Functions | Speech Processor (Adjustable In/Out Levels). Changeable TX Filter Bandwidth. TX Audio Monitor. TX DSP Equalizer. VOX (Adjustable Gain and Delay Time settings). MIC Gain Control. CAR Level Setting. Adjustable Power Output. |
TX/RX Equalizer | |
USB Port | 2 x USB-A for flash drives/keyboard plus 1 x USB-B for PC connectivity |
Variable LCD Brightness with Selectable Dimmer | Four configurable settings |
Video Display Port | DVI port. Selectable 800×600 or 848×480 resolution |
VOX | Separately configurable for voice (SSB, FM & AM) or Data Mode. Adjustable Gain, Delay and Anti-VOX |
Amateur HF Specifications
HF Output Power | 200 W SSB/FM/CW/FSK, 50 W AM |
50 MHz RF Output Power | 200 W SSB/FM/CW/FSK, 50 W AM |
5 W Minimum Output for QRP operation | |
A.C. Supply Voltage | 220 – 240 V (50/60 Hz) |
Antenna Impedance – 50 Ohm | |
Antenna Tunable Range (160 – 6 m Bands) – 16.7 Ohm to 150 Ohm | |
Audio Output Impedance – 8 Ohm | |
Audio Output Power | More than 1.5 W (8 Ohm, 10% distortion) |
Continuous RX: 30 kHz – 60 MHz | Within spec – 0.13 – 30 MHz & 50 – 54 MHz |
Current Drain (approx.) | TX – 840 VA Power Consumption |
RX – 200 VA Power Consumption | |
Frequency Stability | ± 0.1 ppm 0 °C to +50 °C |
Microphone Impedance – 600 Ohm | |
Modes | A1A (CW), A3E (AM), J3E (SSB), F3E (FM), F1B (FSK) & G1B (PSK) |
Notch Filter Attenuation | Auto Mode – More than 60 dB |
Manual Mode – More than 70 dB | |
Operating Temperature Range | -0 °C to + 50 °C |
Receiver Beat Elimination | More than 40 dB |
Receiver Circuitry | Main RX – Double superheterodyne |
Sub RX1 Down Conversion – Double superheterodyne | |
Sub RX2 Up Conversion – Triple superheterodyne | |
Receiver Frequency Range | VFO Coverage = 30kHz – 60MHz |
Main Band spec guaranteed = 0.13 – 30MHz/50-54MHz | |
Receiver IF Rejection Ratio | Less than 70dB |
Receiver Image Rejection Ratio | HF – Less than 70dB |
50MHz – Less than 60dB | |
Receiver Intermediate Frequencies | Main RX – 1st IF 8.248 MHz/2nd IF 24 kHz (FM – 455 kHz) |
Sub RX1 Down Conversion – 1st IF 11.374 MHz/2nd IF 24 kHz | |
Sub RX2 Up Conversion – 1st IF 73.095 MHz/2nd IF 10.695 MHz/3rd IF 24 kHz (FM – 455 kHz) | |
Receiver Selectivity | SSB (LO:200/HI:2800 Hz) – More than 2.4 kHz @ -6 dB/Less than 4.4 kHz @ -60dB |
CW/FSK/PSK (Width: 500 Hz): More than 500 Hz @ -6 dB/Less than 1.2 kHz @ – 60 dB | |
AM (LO:100/HI:3000 Hz) – More than 6 kHz @ -6 dB/Less than 12 kHz @ -60dB | |
FM – More than 12 kHz @ -6 dB/Less than 25 kHz @ -50dB | |
Receiver Sensitivity – 0.13 – 0.522 MHz | SSB/CW/FSK/PSK = less than 0.5µV |
AM = less than 6.3µV | |
Receiver Sensitivity – 0.522 – 1.705 MHz | SSB/CW/FSK/PSK = less than 4µV |
AM = less than 32µV | |
Receiver Sensitivity – 1.705 – 24.5 MHz | SSB/CW/FSK/PSK = less than 0.2µV |
AM = less than 2µV | |
Receiver Sensitivity – 24.5 – 30 MHz | SSB/CW/FSK/PSK = less than 0.13µV |
AM = less than 1.3µV | |
Receiver Sensitivity – 28 – 30 MHz (FM) | Less than 0.22µV |
Receiver Sensitivity – 50 – 54 MHz | SSB/CW/FSK/PSK = less than 0.13µV |
AM = less than 1.3µV | |
FM = less than 0.22µV | |
RIT Frequency Range | ± 9.999 kHz |
Transmitter Carrier Supression | Less than -60 dB |
Transmitter Frequency Response | 300 Hz – 2700 Hz (within -6 dB) |
Transmitter Modulation | SSB/FM/AM = Balanced/Reactance/Low Power |
Transmitter Spurious Radiation | Less than -60dB |
Transmitter Spurious Radiation – 50 MHz | Less than – 66 dB |
Transmitter Unwanted Sideband Supression | Less than -60dB |
XIT Frequency Range | ± 9.999 kHz |
Dimensions | W x H x D = 460 x 182 x 449 mm including projections |
Weight | 24.5 kg |
CW Features
Auto-Weighting, with adjustable manual fixed ratios | |
Built-In Memory Keyer | |
CW Autotransmit | |
CW Autotune | |
CW Pitch Control | Adjustable 300 – 1100Hz |
CW-Reverse Mode | |
Full Break-In/Semi Break-In | |
Iambic Modes A and B Built-in | |
Microphone Paddle Mode | |
Paddle Reverse Function | |
Side Tone Monitor | |
Terminal for CW paddle key | |
Terminal for straight key/external electronic keyer |
Options
External Loudspeaker | SP-990 |
Applicable Standards
CE Marked | |
R&TTE: 1999/5/EC | |
Factory Quality Certification and Location | ISO 9001. Manufactured in Japan |